What is saved where, and when to unplug#
Where things live#
128 MB NAND: the drive logs, and the clock file
Flash files: what R.E.V learned, the settings files and the Wi-Fi list
Internal settings: the pairing with the desktop app, the saved networks, the settings, the model choice and the session counter. Flashing a new firmware image erases these (see Desktop app and updates).
There is no SD card. Without a working NAND, the board logs to the flash as before.
Safe to turn off#
The drive ends when you hold End drive for 1 second. It also ends by itself about 15 seconds after the car stops answering, when you switch the engine off.
Wait for the green Safe to turn off line in the events, then unplug the board. When it is not safe, a red “Not safe” line gives the reason.
The board saves its last known time at most once a minute. After a power cut it starts from that time, and Wi-Fi corrects it later.
Storage that repairs itself#
Before every restart the board finishes its writes. At start it checks its storage and repairs a damaged copy from the good one. It never formats a store that holds data on its own. If a store will not open, use Settings > Format storage.
Format storage erases the 128 MB NAND in about 15 seconds and removes drive logs left on the flash. What R.E.V learned and your settings stay. Import your drives first.
The battery#
The board has a small 3.7 V, 65 mAh cell with a fuel gauge, and it is meant to run on the car’s USB power. The status bar shows the cell’s voltage. The Board page shows its current and temperature and marks the gauge as uncalibrated, because the gauge is not set up for this cell yet.
Battery protection is on (Health checks and messages). Running on the battery when the car’s USB power drops, and finishing the save before turning off, is prepared but switched off in this release.
Note
Dark saves power on an AMOLED
On an AMOLED every lit pixel draws current and black pixels almost none. So at the same brightness the Light theme costs more battery than Dark. Nobody has measured how much yet. To make the screen use less power, choose Dark, lower the brightness or set Screen off.