Coming next#

These parts are built into 2.0.0 but switched off. Each waits for a measurement or a decision.

Battery as a backup supply#

Prepared, off.

When the car’s USB power drops, the board would run on its cell, finish saving and then turn itself off. Cranking the engine drops USB for a few seconds, so it waits 15 seconds first. It stays off until the board’s power draw is measured.

Going back by itself#

Prepared, off.

The flash has room for two firmware images. A new image would get one start to prove itself, and the board would go back to the old one if the health check says bad. This needs a change to how the board is flashed.

A calibrated battery gauge#

Coming.

Setting the fuel gauge up for the 65 mAh cell, so that the charge % and the battery health mean something.

Work has also started on a model that keeps learning more of your car on the board.